|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
104.14.166.252
In Reply to: RE: Oyaide R1 outlet update. posted by alan m. kafton on September 03, 2016 at 17:27:29
Alan,
The TP60 has over 3k hours on it. Would there be some benefit to cooking it at this point?
Follow Ups:
Absolutely. You will be VERY surprised at the results.
Cooking the TP60 will also allow you to re-condition a couple of power cables at the same time, since those need a "recharge" as well.
One power cable would be installed into the IEC inlet of the TP60 (with the wall plug adaptor from the upper left set of binding posts) and the other power cable would be installed from one of the duplexes into the IEC adaptor of the Cooker, and then into the lower right set of binding posts. I recommend conditioning the furthermost duplex (from the IEC) first....then work yourself towards the TP60's IEC in succession. That way you're getting all the length of the internal wiring from the start. Call me if you have any particular questions....I can guide you in real time.
I would give each duplex a couple of days of conditioning. Put it back in your system, then let it draw current for a couple of days, allowing things to settle in before you do any serious listening again. Let us know the results!
OK, I'll give it a try during the work week when I normally don't have much time to listen to music. I assume my Model T vintage Cooker is up to the task? :)
Yes....it should be fine. The green LED might act a little differently due to the increased resistance (and mass) of the contacts within the duplexes, plus the two power cables, just so you are aware. Besides continuity, the green LED displays the pattern of the frequency sweep, which can alter slightly depending on that mass.
For instance, the pattern might look a little different when conditioning large caps, versus a group of power cables, or a daisy-chain of interconnects....the conductor mass is different. Nothing to worry about. It's a reactance issue.
RadioWonder:
Thank you for the pictures of your adaptors to condition multiple outlets at the same time. I have now ordered the materials to do make male to male jumpers to condition five outlets at the same time and have the ability to use the Ground Breaker adaptor so that the ground connection is also conditioned.
I am very impressed with the results of conditioning a Synergistic Research Tesla Plex outlet for six days. There was a significant improvement in an outlet that already had hundreds of hours of use.
The uses and benefits of the AudioDharma Cable Cooker continues to grow.
David Pritchard
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: