|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
97.95.43.235
In Reply to: RE: I'm really loving the EL34/6CA7s with the Mullard 10M 12AX7 posted by DannyR on September 11, 2016 at 23:21:23
Danny
Which DIY board are you using? If you use the VTA-70 with the stock resistors,I don't care for it. The HF87 has superior iron to the ST70 as far as I see.I haven't removed the output transformer to do a comparative sweep, driven by my wide bandwidth Rotel amp.
I am still floored by the EH 6CA7s that I have that test in the high 8000s.I am very tempted to order another quad of them with the same test numbers to see if they sound as good or maybe I just have a unique quad.
"For every complex problem there is an answer that is clear, simple, and wrong" H. L. Mencken
Edits: 09/12/16Follow Ups:
Mike, it's diytube's board.
http://www.diytube.com/phpBB2/viewtopic.php?f=6&t=813
It's the only aftermarket board that has measurements etc in it's instructions. Unfortunately, I believe that it's now out print:(. I'm going to post instructions how to change a KTA70board over to it though. Anyway, it sounds much better than the VTA70 to me but I am going to give the VTA a second shot and i'll do your tweaks to it with a spare st70's and see if I was too hard on it.
Danny
This is the one put out by Ned Carlson right? The VTA uses a much better quality board material than the others.If you have to pull off a part,you don't lift the trace like on some of the others.
"For every complex problem there is an answer that is clear, simple, and wrong" H. L. Mencken
Shannon Parks did it. My VTA board has been though a bit but I think that I can make it work. I have to get some new standoffs though...
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: