|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
173.33.10.228
In Reply to: RE: You will be fine and I don't even have to measure it and here is why. posted by Michael Samra on September 14, 2016 at 22:59:08
You are correct. I hadn't noticed they were rated in AC. They should be fine.
I still would not use them above about 350V though. Too many failures.
However I haven't used them in about 7-8 years as I don't trust them or like the fat sound they impart.
Dan Santoni
Follow Ups:
I still would not use them above about 350V though. Too many failures
I agree. You can use higher voltage on the teflons tho.
"For every complex problem there is an answer that is clear, simple, and wrong" H. L. Mencken
Dear Friends
Also have the same doubt. My tube amp at startup raises the tension to ~410V for about 20 seconds, then after the tubes start to conduct and lowers to lets say 190V. Do you PPL thing it is safe to use a K75-10 250Volts 50hz/AC here? Some say it“s times 1.4 the tention AC to DC, other say it even can go to times 2.4(???scary).
Tnx
Joćo
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: