Welcome! Need support, you got it. Or share your ideas and experiences.
Return to MagneQuest/Peerless Forum
74.215.187.197
In Reply to: RE: SET Headphone amp posted by OldNuke on August 03, 2016 at 11:14:08
ON,
I have built a number of these for customers using the TL404, Dowdy Choke and tube rectifier. I use AC heaters with the 45 and use a 10 or 20 turn hum pot and was able to make the AC noise less than 0.25mV at 60Hz. I don't use any DC regulation but do use a LCLC power supply and usually a 5Y3 rectifier and the LCLC is more like LC---split LC for each channel.
You really have to think about grounding here and the layout.
Thanks,
Gordon
J. Gordon Rankin
Follow Ups:
Thanks for the encouragement! I'll start with some cleanup and move to improving my layout.
Starting at 6.6mV and 10mV on Right and Left channels, shooting for 0.5mV each.
Latest steps: increased last power supply capacitor to 82uF (all I had in the junk box). Changed out the pot and padded the input. Moved TL404, headphone jack and RCA grounds to the same point. Moved speaker connection ground to PS safety ground. Bypassed last PS cap with a 1.0 uF Obligatto gold. Moved BCP-15's around to get the lowest hum heard over headphones. Still at around 10 mV AC on the speaker outputs.
Listening to Gary Clark Jr's album, sounds sweet but the same problems. Hum in the quiet points and just below the music and buzz that can be nulled at 30 -50% of volume pot and increases as pot increases.
I'll tube roll the 12at7 and 45's to get a quiet set while I wait for a BCP-15+ from Mike L, will re route the input wiring away from everything.
A little bit closer to being done.
Cured the buzz by using a .47uf ceramic cap to ground on the filament ground of the input tube.
Added BCP-15+ for plate chokes, at this point I'm at 6mV and 7.2mV hum. Took the padding off the volume pot and put 33 ohms on the input of the TRS jack (all I had in the garage). Still have a little hum in the quiet passages and when input is paused. Ordering more resistors to find the right listening level.
Is the input wiring shielded?
--------------------------
Buy Chinese. Bury freedom.
Yes,
The input wire is a shielded twisted pair with the shield wire connecting RCA inputs ground on one end and star ground on the other.
Well, I think I fixed the issue but I didn't solve the issue. I added a -8db pad onto the TRS jack (38K in series, 49K to ground) that cured all the hum problems. Completely black background on my Oppo PM3's, no hum anywhere.
The pad is a little too much, my first 5 clicks on the volume pot are useless and the max volume is just below the "rocking out" level I want so I'm going to try a -1 or -3db when the grid chokes I ordered come in. I know this is another source of possible hum but I never thought this would be easy :)
Going to try something I saw on the Bottlehead big headphone amp and route the inputs thru grounded copper pipes and relocate my setting switches as far away from the power transformer and the 404's as possible, shouldn't hurt and will make the amp pictures more interesting.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: