|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
68.227.247.96
In Reply to: RE: Pinging Mr. Duster posted by Sondek on December 21, 2016 at 07:56:51
I primarily suggested soldering the Audience OHNO wiring directly (twist the strands, tin, and bend to fit) to the lugs of the Oyaide IEC inlet. Trying to crimp the Oyaide Fastons is a major chore as the metal is quite stiff....and why not eliminate another metal in the way of an easy, clean solder joint (on the lugs)?
Follow Ups:
Well, we can debate the benefits a gas-free crimped connection versus a soldered one until the cows return. That debate has been aired on these forums many times in the past. I find myself in the crimp camp. You sound as though you are in the other camp. Likely we'll never convince one another. I kind of keep coming back to the idea of why introduce a third or fourth or fifth type of metal into the equation by using solder?
....is trying to crimp those non-plyable Oyaide Fastons. There is little give in them. That's one of the reasons why I recommended soldering.
Perhaps if one invests in the ultra-expensive, dedicated crimping tool then you can have your cake, etc. etc. But for just one or two applications?
I have no stake in arguing soldering vs. crimping....whatever you wish is fine with me.
Alan,
I talked again with Mike. He told me he had a cheap (like $40) Klein tool that was very close to being the correct size. He was going to take it to a machinist buddy to see about milling the jaw so it'd be a perfect fit. I'll let you know I what kind of success he has with that. And you are bang on with your assessment of the rigidity of those tabs. Without the correct tool they are a PITA to get them to form a proper crimp.
.
.
.
.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: