62.78.245.117
In Reply to: RE: Upgrades to the new M2 PSU? posted by Klassenfahrt on March 28, 2012 at 17:20:52
Ok, thanks again, and further questions;
I don't know how to read and understand the schematic so I'd need quite detailed instructions how to incorporate the four pole Mundorf into the PCB?
How about the C6 and C7? Is there any point to replace those with oil or polypropylene caps as well?
Follow Ups:
After all it's a very good idea to learn how to read schematics and try to understand what you read. Find a list of the symbols at wikipedia or whereever and read through it. You'll understand the concept pretty fast.
Then you'll see that with the 4 pole cap "+ in" connects to the choke output, "+ out" to the ECL82 pentode side's plate, "- in" and "- out" to the Ground trace. To make it easier connect "- in" to the hole that's there anyways for C3 - and connect "- out" to the GND side of C1. Before that cut the traces that would otherwise short the positive and negative in/outs.
I use the original Rubycons for C6 and C7 so I can't comment on any positive effects when changing them to film caps. I would rather play with different rectifier tubes.
Ok, thank you!
Does anybody have any experience of changing the diodes to schottky diodes and/or replacing the rectifier bridge with four(?) schottky diodes?
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: