Home
AudioAsylum Trader
Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

For Sale Ads

FAQ / News / Events

 

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.

You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login


Login to access features only available to registered Asylum Inmates.
    By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username:

The Name that you picked or by default, your email.
Forgot Moniker?

 
 

Examples "Rapper", "Bob W", "joe@aol.com".

Password:    

Forgot Password?

 Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:  
Your Email:  
Subject:  

Message Comments

   

Original Message

Tecon Model "55" gets a makeover

Posted by 4season on September 7, 2009 at 20:58:25:



I purchased one of these beauties last year. It ships without a schematic, but I was able to trace it out and lay it out in Eagle CAD. With help from others (including Ray Moth, who introduced me to the concept of a "grid stopper" and "parasitic oscillation"), it looked like there was room for improvement of the stock circuit. Square waves looked fuzzy with oscillation, becoming oddly distorted at higher frequencies.



I relocated the grid stoppers thus, and the "fuzz" on the square waves vanished. I also added a 12 pf capacitor in parallel to the 470K ohm feedback resistor, and upped the value of the EL84 cathode bypass capacitor from 180 uf to 220, but more on that in a moment.

(Along the way, I replaced the stock OPTs with Edcors, but that was probably premature)



Modified amplifier, 1 khz square wave:


10khz. I can get more picture-perfect results here if I increase negative feedback, but it seemed to come at the expense of midrange constriction, so I reverted back to the 470K ohm resistor.


20 khz. there was some ringing, and waveforms still looked pretty distorted at higher frequencies. So I added a 12 pf capacitor in parallel to the 470K ohm feedback resistor, and that smoothed over the gremlins nicely. I was surprised to see how such a tiny bit of capacitance has such a profound effect on it's performance. I may be able to get away with a bit less.


What a difference: The stock amp sounded lean, constricted and bass-shy, but the modded amp sounds nice and relaxed with plenty of bass bloom. Maybe a bit too much in fact. I may try downsizing the 0.1 uf coupling capacitor and see what effect that has. Sine wave frequency response still looks essentially flat down to 30 hz, but square waves don't look so hot 'till somewhere around 150 hz, so I don't think I'll be missing much if I roll off some of the lower bass frequencies.

The bulk of the mods were really simple: Just cut 2 circuit board traces, relocate 4 resistors, add 2 jumpers, 2 new capacitors, and replace 2 electrolytics. I'll post photos showing exactly which parts go where later in the week if time allows.