Planar Speaker Asylum

Welcome! Need support, you got it. Or share your ideas and experiences.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

I did ;-)

Posted by wazoo on January 25, 2012 at 18:41:28:
When I flipped the switches to put it in triode mode, I checked the bias (at 10 minutes, 30 minutes and two hours) and it had shifted slightly to the cooler side. It's funny; not since my first time turning it on has the bias meter given a different reading after 10 minutes - started cold and leveled off 'on the mark' for each tube by the one hour point.

I can't give exact bias voltage data because this amp doesn't have accessible test points. It just has a bias meter. Flip the mute switch, then hold each of the eight output tube metering switches while viewing the meter - adjust the adjacent potentiometer as necessary. It's rather ergonomic, if a little less romantic.