Home Vinyl Asylum

Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ.

I see.

> If the floor is a mover, the walls, even if they move, will be moving less.

No, not necessarily. The construction of both surfaces will determine the vibrational modes that each one can sustain, and which one will affect your turntable most cannot be universally determined in advance.

> If the floor is not a mover

There is no such thing in this world.

> On top of that, on a wall mount the table sits on a plith connected to the room by 4 pin point spikes.
> That's about as decoupled as you can get.

Spikes are one of the worst interfaces for turntable support; rather than decoupling, they generate vibrations.

> People can check by simply placing a half full glass on the top of their turntable, moving to the center of the room,
> and jumping. If the water is moving (which is most probably will be) their table is not vibration free.

If that's the extent of your engineering analytic abilities, then by all means, get a non-suspended table, place it on spikes, rollerballs, mpingo discs, whatever, and enjoy the end result.

Good luck in your quest for better sound.

John


This post is made possible by the generous support of people like you and our sponsors:
  K&K Audio / Lundahl Transformers   [ K&K Audio / Lundahl Transformers Forum ]


Follow Ups Full Thread
Follow Ups


You can not post to an archived thread.