|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
|
|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Re: need help with nott horizon/rb250 setup (overhang) posted by Rob Doorack on October 31, 2004 at 08:37:32:
Thanks for the information.But are you suggesting that the arm needs to be the full 222mm in order for the geometry of the clearaudio protractor grid to be accurate?
I still run into the problem that either 219 or especially 222 ends up angling the arm such that the headshell is much too close to the platter edge.
At this point, I'm thinking that I should just lock the armboard at a point where the arm is in a safe location re: the platter, and then use the free protractor from enjoythemusic. Would that still maintain correct geometry, or is that protractor still distance dependant for accuracy as well?
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: need help with nott horizon/rb250 setup (overhang) - imrer 10:57:05 10/31/04 (6)
- Re: need help with nott horizon/rb250 setup (overhang) - Rob Doorack 12:19:42 10/31/04 (5)
- d'oh (insert head slap here) - imrer 12:56:28 10/31/04 (4)
- Re: d'oh (insert head slap here) - Rob Doorack 07:53:56 11/01/04 (3)
- not picky - imrer 19:04:17 11/01/04 (2)
- Re: not picky - Rob Doorack 07:53:55 11/02/04 (1)
- Re: not picky - imrer 13:11:41 11/02/04 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
