Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: RE: I just pulled this tonearm off a freebie, water damaged, old Luxman PD 270 table, so posted by SoundMann on October 16, 2016 at 13:55:42:
Obviously, the set screw must have already been slightly loose when I first tried to rock the headshell. When I finally install the arm, I will check the azimuth and carefully re-tighten the set screw.
I still want to know if this set screw was intended as a method to adjust the azimuth, or was it tightened at the factory and not for use by the owner.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I understand, and I haven't touched the screw since I received the turntable. - alaskahiatt 15:09:25 10/16/16 (1)
- RE: I understand, and I haven't touched the screw since I received the turntable. - SoundMann 21:48:52 10/16/16 (0)