unfortunately logic is no use here

Because everything is in limbo. Jim made a few decisions and he cut the end of the shaft shorter to account for a pad, then he was going to adjust it to make the motor sit at the right hight, but he failed to take measurements before he started, so i sent him an another motor to take measurements off..Then he got sick and could not work on it....you have the rest of the story...

..so the length of the motor shaft has to be adjusted to take into consideration the ball, the thrust pad and the final desired heigh. Because there are no notes or indications which way he was going to go, pad on top or pad on bottom....you see my dilemma? I can make it whatever i feel like making it as long as the end result is the correct height, and since i cannot just call him up anymore....Hey Jim just which way you were thinking this will go...I am thinking that if i base it on his other designs then it will be better. My ouija board is broken.

dee
;-D
True terror is to wake up one morning and discover that your high school class is running the country.

quote by Kurt Vonnegut

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - All you guys out there with Applied Fidelity bearings - Penguin 21:39:59 09/21/16 (13)

All you guys out there - hifitommy 21:59:58 09/22/16 (5)

Zebra joke? - Penguin 17:03:06 09/23/16 (2)

RE: Zebra - hifitommy 17:33:28 09/23/16 (1)

It would not be PC for either of us tell the joke :)... - Penguin 17:59:49 09/23/16 (0)

RE: All you guys out there... - John Elison 23:22:52 09/22/16 (1)

SALUTE! - hifitommy 13:26:12 09/23/16 (0)

Tubes liked to take pictures... - John Elison 06:12:03 09/22/16 (3)

Thanks John - Penguin 10:05:03 09/22/16 (2)

You're welcome! /nt\ - John Elison 18:22:11 09/22/16 (0)

Yes, thanks very much John. - alaskahiatt 12:01:21 09/22/16 (0)

I know for sure - EdAInWestOC 06:00:51 09/22/16 (0)

Logic says the ball below would ride higher, the ball on top lower. Which way sits at correct height? nt - Smelly_Socks 21:54:56 09/21/16 (1)

unfortunately logic is no use here - Penguin 22:26:36 09/21/16 (0)

Follow Ups

unfortunately logic is no use here - Penguin 22:26:36 09/21/16 (0)

unfortunately logic is no use here

Post a Message!