Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Does this look right ? Cartridge mounting posted by Ross on September 15, 2016 at 15:12:08:
Table is a Techincs SP-15
Arm is AT 1503-III
Purchased as a combo
I checked arm location, and measurements are correct.
I verified -0- VTF by setting TF to 0 and adjusting the counterweight so the arm floated level. I set VTF by sliding then locking the set weight.
Arm height is adjustable, and I will lower the arm slightly such that the stylus block is level with the LP surface.
Still troubled about how low the cartridge sits at 1g VTF and wondering about the suspension.
Thanks All.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Followup- - Ross 06:59:36 09/16/16 (0)