Why not a DIY unipivot tonearm...

Posted by cactuscowboy@bresnan.net (A) on December 16, 2014 at 14:18:59

In Reply to: Opinions wanted on a DIY turntable project posted by henrybasstardo on December 14, 2014 at 22:50:15:

My project from a few years ago incorporated a direct drive motor & platter. I designed and built a wooden unipivot tonearm. Parts cost for the tonearm was well under $50, and that included a jewel quality sapphire bearing with matching stainless steel pivot and Cardas tonearm wire.

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - Opinions wanted on a DIY turntable project - henrybasstardo 22:50:15 12/14/14 (14)

Why not a DIY unipivot tonearm... - cactuscowboy@bresnan.net 14:18:59 12/16/14 (2)

RE: Why not a DIY unipivot tonearm... - henrybasstardo 21:18:10 12/19/14 (1)

Or a "String Theory" arm - CometCKO 06:32:58 12/20/14 (0)

Experience is a hard school... - CometCKO 13:49:53 12/16/14 (2)

RE: Experience is a hard school... - henrybasstardo 21:16:24 12/19/14 (1)

Yes, I've been following the Phoenix project - CometCKO 06:25:07 12/20/14 (0)

seconded: go linear - troporobo 16:08:28 12/15/14 (1)

Good arm too! - Dman 05:49:18 12/16/14 (0)

3009 is poor for the money - richardl 12:35:40 12/15/14 (2)

RE: Finally! - amioutaline? 16:15:41 12/15/14 (0)

RE: 3009 is poor for the money - mosin 15:45:27 12/15/14 (0)

Or a Jelco arm - Cuernavaca 08:58:22 12/15/14 (0)

Can't go wrong with the SME... - Dman 05:53:19 12/15/14 (1)

Or a Souther - Paully 13:51:42 12/15/14 (0)

Follow Ups

Why not a DIY unipivot tonearm... - cactuscowboy@bresnan.net 14:18:59 12/16/14 (2)

RE: Why not a DIY unipivot tonearm... - henrybasstardo 21:18:10 12/19/14 (1)

Or a "String Theory" arm - CometCKO 06:32:58 12/20/14 (0)

Why not a DIY unipivot tonearm...

Post a Message!