139.142.233.93
'); } else { document.writeln(''); } } else { document.writeln(''); } } else { document.writeln(''); } } // End --> |
This Post Has Been Edited by the Author
In Reply to: RE: Absolutely remove the Cardas end caps.... posted by alan m. kafton on January 19, 2017 at 04:48:59
I can't remember for sure, but I think I have the long rather than the short version Cardas. So the soldering point is further away from the teflon. This would affect the scenario somewhat versus the short version shown in Duster's original post.
Thinking ahead further, the longer would also let me add extra aluminum nuts to both sides of the barrel for soldering. Then remove the nuts before soldering the other end of the wire.
Thank you Duster for the OP and for explanations that help us put logic into practice.
Cheers!
Jonesy
"I know just enough to get into trouble. But not enough to get out of it."
Follow Ups: