Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: RE: Pleas Recommend Fittings For A Component Matching LCRZ Measurement Jig posted by djk on May 23, 2012 at 02:04:20:
I have found some higher tension spring loaded Kelvin clips that I am happier with than the brass shim stock:
http://www.newark.com/silvertronic/502001/insulated-kelvin-clip/dp/82R5334
I'm going to superglue the bottom of these to a small rectangle of plexiglass, drill two holes in the plexiglass and screw the clips to a scrap piece of 2x4.
In this way, the clips will be fixed (=repeatable measurements),they will have good grip tension, and I can change their orientation pretty easily by relocating the screws on the 2x4.
Of course I'm anal. This is the Tweaks/DIY forum!
ccm
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Pleas Recommend Fittings For A Component Matching LCRZ Measurement Jig - Coffeecupman 17:51:27 05/23/12 (0)