Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: RE: Life Test - How Important? posted by Steve O on September 17, 2016 at 10:43:36:
Especially for power tubes because most testers just do not put enough DC across the tube to get to get a real indication. I measure B+ across a KT88 from plate to cathode in the Hickok 539c and it was 150vdc. When I measured it across the Heathkit TT-1,it was 275vdc.While neither is near the operating voltage of a typical KT88,that extra 125vdc does help to give a more accurate picture of the tube IMHO.I do like some tests on the 539c such as the noise test with an AM radio however,I did set up add a couple input and output jacks where I can inject and monitor the signal of dual triodes on the TT-1.
"For every complex problem there is an answer that is clear, simple, and wrong" H. L. Mencken
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Life Test - How Important? - Michael Samra 20:17:58 09/17/16 (0)