Another method.

Another method.

Posted by Rick W on December 17, 2014 at 09:53:31

In Reply to: SilClear hardening posted by Dave Pogue on December 16, 2014 at 05:33:09:

Dave, I put my jar of that stuff in a wire mesh strainer and placed it above - not immersed in - a small pot of boiling water for 2-3 minutes. This loosened it up and got it back to approx. the original consistency. Heated it up *just a tad*, then mixed it up a bit with the supplied applicator.

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - Mapleshade Sil-Clear - geezerrocket 18:56:39 12/15/14 (17)

My Experience - Awe-d-o-file 08:30:08 12/16/14 (6)

I've heard... - genungo 09:13:20 12/16/14 (0)

Pierre Sprey Says....... - geezerrocket 09:04:41 12/16/14 (4)

So, basically naphtha? - -æ- 10:08:03 12/16/14 (3)

RE: So, basically naphtha? - geezerrocket 12:57:02 12/16/14 (1)

No, unleaded gasoline...no ethanol NT - Coner 18:46:19 12/16/14 (0)

Actually, VM&P naphtha would be just the ticket... - Steve O 12:35:52 12/16/14 (0)

RE: Mapleshade Sil-Clear - bjh 08:26:20 12/16/14 (0)

SilClear hardening - Dave Pogue 05:33:09 12/16/14 (2)

Another method. - Rick W 09:53:31 12/17/14 (1)

That's probably a better idea than ... - Dave Pogue 13:14:48 12/17/14 (0)

"Should I chuck it?" Absolutely - Chip647 05:03:42 12/16/14 (0)

This may help..... - Winston Smith 23:24:41 12/15/14 (0)

RE: Mapleshade Sil-Clear - Coner 20:18:02 12/15/14 (2)

RE: Mapleshade Sil-Clear - Old SteveA 08:58:18 12/16/14 (0)

"I'd put just enough alcohol in it to get it back to normal." - Chip647 05:00:40 12/16/14 (0)

Well, it contains silver... - genungo 20:05:37 12/15/14 (0)

Follow Ups

Another method. - Rick W 09:53:31 12/17/14 (1)

That's probably a better idea than ... - Dave Pogue 13:14:48 12/17/14 (0)

Post a Message!