In Reply to: Swamped by morse code from HAM Op next door into Sony STR-DA2400ES posted by Firebirduk on July 24, 2014 at 14:28:48:
Your neighbor is almost certainly correct: the problem is with your gear, not his, if the interference happens, as you say, when you are playing recordings and not doing any radio or TV reception.
You will have to try combinations of different equipment and cables to isolate the component(s) and cable(s) that are reacting to perfectly legitimate RF signals that they should be rejecting because they are not in the audio frequency band.
Switching off a component is just one isolation technique. Connecting and disconnecting wires is more likely to be critical. I suggest you follow a "start small" diagnostic strategy of connecting just the amplifier and speakers and then adding additional wires and components one at a time. Remember, "Every wire is an antenna."
Tony Lauck
"Diversity is the law of nature; no two entities in this universe are uniform." - P.R. Sarkar
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Swamped by morse code from HAM Op next door into Sony STR-DA2400ES - Tony Lauck 14:43:57 07/24/14 (0)