|
Digital Drive Upsamplers, DACs, jitter, shakes and analogue withdrawals, this is it. |
|
|
|
Digital Drive Upsamplers, DACs, jitter, shakes and analogue withdrawals, this is it. |
|
In Reply to: Replacement for Sony 213Q laserhead posted by akolegov on December 19, 2016 at 00:52:06:
"Intermittent noise" like "skipping?" May not be the laser head. You could try cleaning it. Also test it's tracking capabilities with a simple triangle of masking tape on the data side. Narrow end near spindle. See when it starts to mis-track.
Otherwise, your intermittent noise may be caused by the tubes, sockets and or pins needing a clean. Also your CDP model is prone to bad solder joints.
Don't know of any laser head assembly upgrades.
Good luck!
Jonesy
"I know just enough to get into trouble. But not enough to get out of it."
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Replacement for Sony 213Q laserhead - Jonesy 08:10:48 12/19/16 (1)
- RE: Replacement for Sony 213Q laserhead - akolegov 09:00:52 12/19/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
