In Reply to: V-Twist Construction Help posted by WntrMute2 on September 10, 2016 at 15:40:18:
Used Hakko Solder Station... Cardas Quad Eutectic Solder... CW brand "No clean Flux Dispensing Pen (part # CW8100)...
I found Pre-Tinning cable and RCA pins very helpful... You can also use Vise Clip Tool to hold if you need it...
I plugged my male RCA Connectors into old DVD Player for a Heatsink...
After everything is Pre-Tinned and held in place, a little Silver Solder applied to joints is all you need... Make sure your heat is perfect, you do not want Cold Solder Joints...
Because the V-Twist is soft, I used Heatshrink to keep the Set Screws from doing any damage... You need very little pressure when setting the Set Screws on the male RCA Connectors...
After I was finished I used my Audiodharma Cable Cooker to condition cables for three to four days...
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I also made these same interconnects... - RadioWonder 04:48:07 09/11/16 (7)
- A note about the Heatshrink... - RadioWonder 05:43:58 09/11/16 (4)
- RE: A note about the Heatshrink... - WntrMute2 09:43:19 09/11/16 (3)
- RE: A note about the Heatshrink... - RadioWonder 10:00:36 09/11/16 (2)
- RE: A note about the Heatshrink... - Duster 10:25:07 09/11/16 (0)
- RE: A note about the Heatshrink... - RadioWonder 10:24:46 09/11/16 (0)
- RE: I also made these same interconnects... - RadioWonder 05:00:21 09/11/16 (1)
- RE: I also made these same interconnects... - RadioWonder 05:06:41 09/11/16 (0)