In Reply to: RE: FI-11 posted by sideliner on May 21, 2016 at 14:13:59:
With so many strands of bundled wire tightened within the termination clamps, I recommend an initial tightening of the termination screws, then give it a rest for a minute, then tighten the screws again. Do this a few times until the screws can no longer be tightened, but don't go nuts trying to torque them too much, since damage can be done to the connector (and your hand for that matter).
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: FI-11 - Duster 14:37:40 05/21/16 (0)