In Reply to: RE: Far more than 30 hours needed posted by Kim S. on April 23, 2016 at 02:36:59:
After the first 30 hours, you may have experienced the typical preliminary burn-in time of solder joints. While the cellular FEP/Teflon insulated V-Twist requires ample burn-in time, the cable should sound quite good from the start, however a bit congested, since the low-mass AirLok dielectric involves minimal dielectric absorption. I recommend setting an alert/reminder to note obvious improvements at the 250 hour mark, with the stipulation that subtle improvements will continue to develop after many more hours of burn-in time.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Far more than 30 hours needed - Duster 12:07:12 04/23/16 (0)